Cluster announce ip/port/bus-port documented in redis.conf.

redis.conf

@@ -835,6 +835,39 @@ lua-time-limit 5000
 # In order to setup your cluster make sure to read the documentation
 # available at http://redis.io web site.
 
+########################## CLUSTER DOCKER/NAT support  ########################
+
+# In certain deployments, Redis Cluster nodes address discovery fails, because
+# addresses are NAT-ted or because ports are forwarded (the typical case is
+# Docker and other containers).
+#
+# In order to make Redis Cluster working in such environments, a static
+# configuration where each node known its public address is needed. The
+# following two options are used for this scope, and are:
+#
+# * cluster-announce-ip
+# * cluster-announce-port
+# * cluster-announce-bus-port
+#
+# Each instruct the node about its address, client port, and cluster message
+# bus port. The information is then published in the header of the bus packets
+# so that other nodes will be able to correctly map the address of the node
+# publishing the information.
+#
+# If the above options are not used, the normal Redis Cluster auto-detection
+# will be used instead.
+#
+# Note that when remapped, the bus port may not be at the fixed offset of
+# clients port + 10000, so you can specify any port and bus-port depending
+# on how they get remapped. If the bus-port is not set, a fixed offset of
+# 10000 will be used as usually.
+#
+# Example:
+#
+# cluster-announce-ip 10.1.1.5
+# cluster-announce-port 6379
+# cluster-announce-bus-port 6380
+
 ################################## SLOW LOG ###################################
 
 # The Redis Slow Log is a system to log queries that exceeded a specified